TDS-100H Portable Flow Meter ultrasonic
TDS-100H Portable Flow Meter ultrasonic

TDS-100H Portable Flow Meter ultrasonic

2 minutes, 32 seconds Read

ultrasonicHand-Held Flow Meter | Portable Flow Meter

The TDS-100H ultrasonic flow meter is designed to measure the fluid velocity of liquid within a closed conduit.  The transducers are a non-contacting, clamp-on type, which will provide benefits of non-fouling operation and easy installation.

The TDS-100H transit time flow meter utilizes two transducers that function as both ultrasonic transmitters and receivers. The transducers are clamped on the outside of a closed pipe at a specific distance from each other.

The transducers can be mounted in V-method where the sound transverses the pipe twice, or W-method where the sound transverses the pipe four times, or in Z-method where the transducers are mounted on opposite sides of the pipe and the sound crosses the pipe once.  This selection of the mounting method depends on pipe and liquid characteristics.

The flow meter operates by alternately transmitting and receiving a frequency modulated burst of sound energy between the two transducers and measuring the transit time that it takes for sound to travel between the two transducers.  The difference in the transit time measured is directly and exactly related to the velocity of the liquid in the pipe. The TDS-100H can be used for Carbon steel, Stainless steel, copper, PVC, Rubber tubes, etc

TDS Handhle

TDS series Handheld Ultrasonic Flow Meters are based on a clamp-on transit-time flow measurement principle. It measures the flow rate of liquid in a pipe from the outside of the pipe by using a pair of ultrasonic transducers. In general, the liquid should be full in the pipe and should contain very little particles or bubbles.

It is applicable for water (hot water, chill water, city water, seawater, etc.); sewage; oil (crude oil, lubricating oil, diesel oil, fuel oil, etc.); chemicals (alcohol, acids, etc.); waste; beverage and liquid food, solvents and other liquids. TDS-100H handheld ultrasonic flow meter is a battery-powered ultrasonic flow meter with the capability of a full-size flow meter. It is carefully designed for portability and ease of use.

Technical Specification:
Linearity : 0.5%
Repeatability : 0.2%
Accuracy : ±1% of reading at rates>0.2 mps
Response Time : 0-999 seconds, user-configurable
Velocity : ±32 m/s
Pipe Size : 20mm-6000mm
Rate Units : Meter, Feet, Cubic Meter, Liter, Cubic Feet, USA Gallon, Imperial Gallon, Oil Barrel, USA Liquid Barrel, Imperial Liquid Barrel, Million USA Gallons. User-configurable.
Totalizer : 7-digit totals for net, positive and negative flow respectively
Liquid Types : Virtually all liquids
Security : Setup values Modification Lockout. Access code needs unlocking
Display : 4×16 English letters
Communication Interface : RS-232C, baud-rate: from 75 to 57600. Protocol made by the manufacturer and compatible with that of the FUJI ultrasonic flow meter. User protocols can be made on inquiry.
Transducers : Model M1 for standard, other 3 models for optional
Transducer Cord Length : Standard 2×10 meters, optional 2x 500 meters
Power Supply : 3 AAA Ni-H built-in batteries. When fully recharged it will last over 10 hours of operation.100V-240VAC for the charger
Data Logger : Built-in data logger can store over 2000 lines of data
Manual Totalizer : 7-digit press-key-to-go totalizer for calibration
Housing Material : ABS
Case Size : 100x66x20mm
Handset Weight : 514g (1.2 lbs) with batteries


Similar Posts

Skip to content